Manitowoc Ice Ice Maker 7626803 User Manual

7626803, 7626813, 7626823, 7626833  
Gear Motor/Reducer Assembly  
1. Disconnect power to machine before beginning any work.  
2. Remove rear panel and open the front to get at the control box.  
3. Disconnect gear motor leads and remove gear motor from machine. Remove old gear box support brackets from  
base.  
4. Remove electronic start winding switch (Sinpac) from control box (Fig. A).  
5. Remove old start or run capacitor and replace with RUN CAPACITOR in this kit. NOTE, capacitor bracket may  
need to be bent to hold the capacitor snug (Fig. A).  
6. Reinstall the new gear motor or gear motor/reducer assembly. Using the new gear box support brackets, supplied  
with this kit, install so the brackets fit tightly under the gear box.  
7. Wire the new gear motor according to the wiring label in this kit and install new wiring label over the old wiring  
label.  
8. Reinstall the pulley on the gear box shaft so that it lines up with the rear pulley on the machine.  
9. Reinstall control box cover and supply power to the machine. Run to insure the belt alignment is correct.  
10. Reinstall back cover and close front.  
Manitowoc Ice, Inc.  
2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA  
Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879  
8010203  
.
Rev. 03/11/99  
 

Kyocera Printer FS 1116MFP User Manual
Liebert Surge Protector 100 2 User Manual
Lincoln Electric Welder SVM141 A User Manual
Lok8u GPS Receiver num8 User Manual
LOREX Technology Security Camera CVC8010 User Manual
LST Smoke Alarm HT 11003 User Manual
Manitowoc Ice Ice Maker K00346 User Manual
Marmitek Universal Remote Easycontrol 6 User Manual
MB QUART Car Speaker PKC 110 User Manual
Memorex CD Player MP3207 User Manual